All Guitar Chords · Forum archive

Combo amp to cabinet

Domigan_Lefty · 2012-01-21 09:25

My dad found and bought a Hartke "piggyback" 4x8 "mini-stack" speaker cabinet with no head. It has a minimum impedance of 4 ohms. I tried connecting my fender frontman 212R to it, but no sound is coming out. It has an output impedance of 4 ohms. The wattage and impedance match, so why cant I get sound? I connected my multi fx directly to the cabinet and was able to get some (not loud) sound, so the cabinet works. Any ideas or suggestions?

telecrater · 2012-01-21 09:49

Honestly my guess is you have a bad cable or maybe the cab is not wired right. You can test the speaker and cable by plugging them in with your normal 1/4 cord and taking a good 9v batter and touching the ends between the tip and the shaft. You should be able to hear a click Just a note not matching impedance can f-up your speakers pretty quick. but it sounds like your doing it right. are you using the frontmans ext speaker or some other way?

Domigan_Lefty · 2012-01-21 11:42

It has a "Pre-out" output that im using. No speaker-out output. The 9volt makes a click at a normal volume. (with just cable to input)

Notim · 2012-01-21 15:51

Make sure you using a head to cab cord...using a guitar cord will cause your head to work to hard and mess it up...hard to say Dom sounds like your doing it right like tele said...

telecrater · 2012-01-22 17:35

You will need to use the ext speaker. the pre-out sounds more like a an effects loop and does not have any juice to push you speaker. If you can post some picks i can double check that or i can post some picks of my amps if that would help

Domigan_Lefty · 2012-01-22 18:48

There is no separate ext speaker. The manual says the pre out doubles as fx loop and ext speaker. There are no plugs on the back, only power and reverb