All Guitar Chords · Forum archive

Helpp pleasee

deadman2k666 · 2010-05-02 15:04

So I just installed new pickups onto my Squier Telecaster. (MIA Fender Telecaster Pickups)Anyways when I select either my bridge or neck pickup it sounds fine, when i select both pickups(middle position on selector) it becomes mega quiet and crap sounding. Does anyone have a clue what could have caused this?

BodomBeachTerror · 2010-05-02 15:39

maybe the pickup is too low?

deadman2k666 · 2010-05-02 15:41

i dont think so, cause both of the pickups sound fine on their own, but when i want to use both of them at the same time it loses quality

Ozzfan486 · 2010-05-02 16:19

Check the wire that's activated when it's in that position? You DID just replace the thing so you might have knocked something out of place.

case211 · 2010-05-02 21:00

Definitely check the switch, you may have not soldered something or you may have a bad connection. Hard to tell without looking at it though.

deadman2k666 · 2010-05-03 15:16

i didn't solder anything, i cut the wire close to the pickup, and just spliced the old wire to the new pickup, put some heat shrink over it